Holding the components in the mold

During injection, the resin pushes on your components: they must be held in place.

Left, the board is held in place during injection. Right, nothing holds it: the resin moves it.
Left, the board is held in place during injection. Right, nothing holds it: the resin moves it.

In short

The mold holds your components by spots left accessible: a flat face, a mounting hole, a connector body. At those spots, the resin does not cover the component.

Why it matters

A component held nowhere can move under the push of the resin, and end up tilted or too close to the surface. When nothing can hold it, the part is made in two injections.

What you can do

Would you rather we handle it?

You do not have to fix your files yourself. At the “Analysis” step of your project, choose “Fillio proposes the changes”: our team adapts the shape and submits it to you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.