Wall slope (draft angle)
A slightly tilted wall releases from the mold without rubbing.
In short
Draft is a small slope given to the walls that run along the mold's opening direction. Stackable cups are the example: their tilted sides let them separate effortlessly.
Why it matters
A perfectly straight wall rubs against the mold over its full height as the part comes out: it can be marked, and the part releases less easily. This is most often a possible improvement, not an obstacle.
What you can do
- Tilt the tallest walls by a few degrees.
- Round the edges: this also helps the part release.
- If a face must stay perfectly straight (seating, assembly), tell us.