The parting line: where the mold opens

An overmolding mold is made of two halves. Knowing where they meet helps you read almost every other point of the analysis.

The two mold halves pull apart to release the part; the dotted line is the parting line.
The two mold halves pull apart to release the part; the dotted line is the parting line.

In short

The two mold halves close around your components, the resin is injected, then they pull apart in a straight line to release the part. The surface where they meet is called the parting line; the direction in which they pull apart, the opening direction.

Why it matters

The parting line leaves a fine visible line on the part, and cables exit at its level. Our analysis proposes one from the shape of your part: it is a proposal, which we confirm with you.

What you can do

Would you rather we handle it?

You do not have to fix your files yourself. At the “Analysis” step of your project, choose “Fillio proposes the changes”: our team adapts the shape and submits it to you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.