Cable exits

A cable holds and stays sealed if it is held far enough into the resin and exits at the right place.

Left, the cable exits straight, level with the parting line. Right, it exits offset and at a slant.
Left, the cable exits straight, level with the parting line. Right, it exits offset and at a slant.

In short

The mold closes around each cable where it leaves the part. The cable must therefore exit level with the parting line, straight, and be surrounded by resin over some length inside.

Why it matters

A cable that exits away from the parting line or at a slant gets pinched by the mold, or lets resin escape. A cable surrounded over too short a length can slide when pulled, and moisture can follow the jacket.

What you can do

Would you rather we handle it?

You do not have to fix your files yourself. At the “Analysis” step of your project, choose “Fillio proposes the changes”: our team adapts the shape and submits it to you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.