The path of the wires to the connector

Between the end of the jacket and the connector, nothing holds the wires: the shorter and straighter this path, the better they stay in the heart of the resin.

Left, short wires and a wide bend: they stay in the heart of the resin. Right, long wires bent tight: one of them shows at the surface.
Left, short wires and a wide bend: they stay in the heart of the resin. Right, long wires bent tight: one of them shows at the surface.

In short

Behind a solder connector, the conductors leave the cable jacket, spread out and each reach their contact. Over this length, they are loose. If the cable also has to turn at a right angle right behind the connector, the wires are pulled toward the outside of the bend.

Why it matters

During injection, the resin pushes a loose wire against the mold wall: its insulation shows at the surface of the part. On a finished part, that is a defect, whatever the level of requirement. A tight bend also pulls on the solder joints. When the shape leaves no other choice, the part is made in two injections: the first sets the wires in place, the second covers them and gives the final shape. That means one more mold and one more step.

What you can do

Is your design not final yet?

This is the best time to talk about it. Upload your drawings to the portal, even as drafts, and say in your notes that the board or the wiring can still change: a Fillio specialist looks at the connection with you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.