Choosing a cable that overmolds well

The resin comes in hot and has to bond to the cable: the material of its jacket and of its insulation decides both.

Left, the insulation keeps its shape in the resin. Right, it has melted and two conductors touch.
Left, the insulation keeps its shape in the resin. Right, it has melted and two conductors touch.

In short

Inside the overmold, the cable jacket is stripped away: the conductors, already heated by soldering, are in direct contact with the hot resin. Where the cable exits, the resin closes onto the jacket. So the insulation must withstand the heat of injection and the resin must bond to the jacket; the cable's data sheet gives the material and the maximum temperature of each.

Why it matters

Thin insulation meant for a moderate temperature can soften or melt during injection: two conductors, or a conductor and the shield, then touch inside the part, where nothing shows and nothing can be repaired. And if the resin does not bond to the jacket, the cable can slip and moisture can follow it to the solder joints. With such a cable, no amount of care in assembly guarantees the result.

What you can do

Is your design not final yet?

This is the best time to talk about it. Upload your drawings to the portal, even as drafts, and say in your notes that the board or the wiring can still change: a Fillio specialist looks at the connection with you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.