An assembly that can be checked at every step

A fault found before injection can be fixed; afterward, it is sealed in the resin.

Left, the assembly is checked before injection, then after. Right, a fault found after injection stays sealed in the resin.
Left, the assembly is checked before injection, then after. Right, a fault found after injection stays sealed in the resin.

In short

An overmolded cable is checked electrically twice: before injection, then after. The check confirms that each conductor reaches the right contact and that none touches its neighbor or the shield. The resin is opaque: once the part is molded, this test is the only look inside. To prepare it, we need to know which contact goes where, and what the board itself connects.

Why it matters

Before injection, a solder joint is easy to redo; afterward, the part has to be remade. An incomplete wiring table, a pinout drawn without saying which side it is seen from, a component that connects two conductors without the check knowing: each one gets good parts set aside or lets a fault through.

What you can do

Is your design not final yet?

This is the best time to talk about it. Upload your drawings to the portal, even as drafts, and say in your notes that the board or the wiring can still change: a Fillio specialist looks at the connection with you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.