Connecting the shields

A shield is a bare conductor: it needs its own pad, at the edge of the board.

Left, each shield reaches its pad at the edge of the board, and a trace links them. Right, the shields joined above the board touch a component.
Left, each shield reaches its pad at the edge of the board, and a trace links them. Right, the shields joined above the board touch a component.

In short

The braid or drain wire of a shielded cable has no insulation. In a splitter, the shields of several cables must be joined: the safest way is to give each one its own pad on the board, on the side of its cable, and to link them with a trace.

Why it matters

Shields soldered to one another above the board, with no sleeve, can fold onto a component or a nearby solder joint when the resin pushes them: the short circuit ends up sealed inside the part. A shield pad placed in the middle of the board lowers this risk without removing it: the bare shield still has to pass over the other pads.

What you can do

Is your design not final yet?

This is the best time to talk about it. Upload your drawings to the portal, even as drafts, and say in your notes that the board or the wiring can still change: a Fillio specialist looks at the connection with you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.