Branching without a board (splices)

When a conductor splits in two without a board, the joint sits inside the overmold: staggered, sleeved, away from where the cable bends.

Left, staggered splices, each under its sleeve. Right, bare splices at the same spot: they touch.
Left, staggered splices, each under its sleeve. Right, bare splices at the same spot: they touch.

In short

A splice joins two or three wires, by soldering or crimping. In a Y cable, there is one per conductor. All at the same spot, they form a bulge and their bare parts face one another; staggered along the cable and each covered with a sleeve, they stay slim and insulated from one another.

Why it matters

During injection, the resin moves the wires: two bare splices side by side can touch, and the short circuit ends up sealed inside the part. A splice is also a stiff spot: where the cable bends or is pulled, it fatigues and eventually breaks.

What you can do

Is your design not final yet?

This is the best time to talk about it. Upload your drawings to the portal, even as drafts, and say in your notes that the board or the wiring can still change: a Fillio specialist looks at the connection with you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.