Solder pads in line with the cable

A wire soldered in line with the cable puts no strain on its solder joint.

Left, the wire comes in straight and is soldered flat on a pad at the edge of the board. Right, it bends at a right angle to enter a hole in the board.
Left, the wire comes in straight and is soldered flat on a pad at the edge of the board. Right, it bends at a right angle to enter a hole in the board.

In short

On an adapter board, each conductor of the cable lands on a pad. Placed at the edge of the board, on the side where the cable comes in, and elongated along its axis, the pads take each wire lying flat, with no change of direction. Surface pads suit this better than through-holes, where the wire has to dive into the board.

Why it matters

A wire bent at a right angle just before its solder joint, on a tight radius, pulls on it permanently, and the resin pushes it further during injection. Small or crowded pads take longer to solder and leave little margin before a drop of solder bridges two neighbors.

What you can do

Is your design not final yet?

This is the best time to talk about it. Upload your drawings to the portal, even as drafts, and say in your notes that the board or the wiring can still change: a Fillio specialist looks at the connection with you.

Feedback

Give us feedback

We read every message.

For a question about a request in progress, write to us at service@fillio.ca.